This category is for all the traditional width Glocks®. If you're shooting a 9mm, 40 Smith & Weston, 380Auto, or 357 SIG, this is your category. If you're shooting a Slimline® (G42,G43,G43x,G48,etc), please select the Slimeline® category.
Standard RMR cut will be 0.125” deep into the slide and 0.050” in front of the OEM rear iron sight position (bottom of the dovetail, so thinnest portion between the two surfaces). The holes will be drilled and tapped for #6-32 countersunk screws, which will be provided. Due to the width of the mounting pattern, the right screw hole WILL be drilled into the extractor spring bore, but will be reamed afterwards to ensure proper functionality of your extractor plunger/spring. With that said, if the red dot is removed for any reason once you receive it, note that one screw will be shorter than the other to ensure that there is clearance for your extractor plunger/spring on one side, but extra thread engagement on the other.
If you don't see a footprint that you're looking for, please reach out. We are always looking to expand our options.
When shipping your slide, send the upper assembly complete, minus the barrel and recoil spring. This will allow us to verify the fit of the red-dot against the other components (mainly the extractor depressor plunger). If you send the slide with new iron sights, we'll install them for free. DO NOT SEND THE LOWER PART OF YOUR FRAME.
Please send your red dot with your slide. From our experience, every red dot is a little unique. We want to make sure you get the best possible fit.
Check out our Shipping & Dropoff page for details on lead-time and how to ship items to us.
