Glock Optic Cut - MOS

This is for cutting a Glock® to us there factory MOS footprint.

With the exception of the 10mm and 0.45 caliber Glocks ( 20, 21, 40, 29, etc), the OEM rear iron on non-MOS pistols will need to be removed in order to fit this footprint. This is due to Glock milling them much further forward on the non-MOS pistols, not leaving enough room between the firing pin block bore and the dovetail. That said, there is enough remove to cut a new dovetail in front of the MOS cut, because the MOS cut will be cut to the far back of the slide.

Information about our Angry Bear Iron Sights can be found here: https://vigilantemachine.com/iron-sights/

When shipping your slide, send the complete upper assembly, to include the barrel and recoil spring. This will allow us to verify the fit of the red-dot against the other components (mainly the extractor depressor plunger). If you send the slide with new iron sights, we'll install them for free. DO NOT SEND THE LOWER PART OF YOUR FRAME.

Please send your red dot and mounting plate with your slide. From our experience, every red dot and plate are a little unique. We want to ensure you get the best possible fit.

Check out our Shipping & Dropoff page for details on lead-time and how to ship items to us. 

To keep things simple, we've chosen to use these cerakote colors:

- Blackout E-100

- FDE H-265

- OD Green H-236

- Burnt Bronze H-148

- Titanium H-170

If you'd like to see a different color, please select other and specify in the comments. There will be an upcharge for using a color outside of our standard color ways.

If black nitride is selected, know that this is an out of house process. Turn around time is out of your control, but the average turn around time is 5 weeks. This is a volume based service, so we need to have a certain amount of slides in order to send them out.

If you don't see the footprint or the firearm that you're looking for, please reach out. We are always looking to expand our options.